USING LOUDSPEAKER DIAPHRAGM FOR DETERMINING THE SOUND LEVEL OF DIFFERENT IMPEDANCE
A. P. ALFA
Department of Physics, Kogi State University, Anyigba, Nigeria.
ABDUL SUNDAY *
Department of Mathematics, Kogi State College of Education, Ankpa, Nigeria.
*Author to whom correspondence should be addressed.
Abstract
This paper work describes a study of a loudspeaker sound level and its modes of vibration using different impedance. Results obtained show that diaphragms that utilize a flat or shallow height produce higher frequencies, as opposed to deeper heights which are better for lower frequencies. In other to get the similar sound level, 4 ohms require more while 8 ohms require less powerful amplifier to arrive at the same maximum output when compared to 16 ohms. The lower the impedance the higher the power handle and the lower the sensitivity numbers. 4 ohms speakers place a significantly heavier demand on power amplifier as compared to 8ohms because of their lower impedance, twice as much current will flow through a 4 ohms speaker as compared to the 8 ohms and 16 ohms respectively. For a given volume setting, also comparing the three cones with different impedance, it was observed and evident that the 16 ohms impedance cone when mounted on the same rated permanent magnet produced the highest sound for low power drive as measured by the sound level meter when compared with the other two cones.
Keywords: Diaphragm, impedance, sound level, loudspeaker.
How to Cite
Downloads
References
Ballou Glen. Handbook for Sound Engineers. 4th Ed (In French). Taylor and Francis. 2013;597.ISBN: 978-1136122538.
Talbot-Smith Michael. Audio Engineer's Reference Book .CRC Press. 2013;2.52.
ISBN: 978-1136119743.
Eagle J, Gander M. Historical prospective and technology overview of loudspeaker for sound reinforcement. Journal of the Audio Engineering Society. 2004;552(4):412432.
Davis D, Carolyn D. Sound System Engineering (2nd Edition). Focal Press. 1997;350362.
ISBN: 13978024080350.
Dean EA. Atmospheric effects on the speed of sound. The US Army Electronic Research and Development Command, Atmospheric Sciences Laboratoery. 1979;60.
Davis S. Kyle. Design requirements for amps and speakers. Harman Publication Samsung Company; 2017.
Marty Mccann. Impedance in audio technology. Peavey Electronics, South African; 2017.