Journal of Basic and Applied Research International

This paper presents an application's experience of technical condition state estimation of electrical equipment. With the passage to the system of the repairs of electrical equipment “to on- state” and the introduction of the system of planning the resources of enterprise in  FGC UES Company planning measures for maintenance and repair of electrical equipment rose to qualitatively different level and, as consequence increased the requirements, presented to the estimation of equipment state.

Before the specialists of divisions, who carry out diagnostics of electrical equipment, arose the complex of questions, without solution of which was impossible the realization of all effective tools of the productive system ASU of maintenance and repair and final passage to repair system “to on- state”.

The task lies in the fact that considerably descending, or more precisely to in practice exclude error is possible with the use of information tools. By information tool in this work is implied software, located on stationary computer or on noutbuk.

As a whole by information tool it is possible to understand the specialized automated working place (further SAWP).

To make decisions as to evaluate controlling influences in the company possible being only based on the estimation of technical condition state (TCS).

In the article is examined the general relationship of errors in those influencing the quality of the estimation of the technical condition state of electrical equipment and so the way of their decrease and of the eliminations of reasons, which cause errors. The use of special information tools (software) will make it possible to considerably decrease the subjective errors, which appear in the process TCS electrical equipment.

Making a decision about development and introduction in FGC Company of the tools of similar SAWP is extremely necessary, since TCS has a significant effect on the total effectiveness of company.